PDF PG16 Hose Pulsation Damper Part Numbers Printable Version
Pulsation Dampers Sizes - Peristaltic Hose Pumps / Connections / Part Numbers
|
Pulsation Damper Size Selection Tables for Hose, Tube, & Peristaltic pump Systems.
|
|
1. Dampers listed below are from 1000s of "off the shelf" inventory dampers, for preventing pipe systems from converting hose flow fluctuation into pressure pulsation. Call toll free 1-888-DAMPERS (326-7377) for discounts, etc. Choose a damper matching your pump connection size, for standard damping. Or allow us to calculate for you, from your smoothness required and your system data. |
2. Where no OSHA requirement for in place flush before service, nor process need for 1st in 1st out, constant temperature, change of liquid pumped, interception of pressure pulsation; use second connection to save a "T" for RV. PI, or System Drain. 2 connection dampers are standard lowest cost. Waveguard and Dampers for 10Hz. & above, IE systems 300 meters (1,000ft.) or less, must use FLOW-THROUGH. |
INSTRUCTIONS: |
4. Please choose the damper part number from the table , which has the same connection size as your pump.
5. We have made these "pre-engineered" selections for you, on the basis of 40 years experience, and average
application circumstances.
6. Please call us toll-free 1-888-DAMPERS (326-7377) with the part number chosen from the tabulation. We will then
find the current price for you. |
4. Where no OSHA requirement for in place flush before service, nor process need for 1st in 1st out, constant temperature, change of liquid pumped, interception of pressure pulsation, or preventing sedimentation; use second connection to save a "T" for RV. PI, or System Drain. 2 connection dampers are standard lowest cost. |
PUMPS make FLOW, SYSTEMS cause PRESSURE, pressure pulsation is a system response, AND a system responsibility NOT a pump manufacturers liability. |